Table of Content
Roll-in showers provide easier access for those who do not wish to transfer. However, many people need to transfer from wheelchairs to either a shower seat or shower chair. For these reasons, designs that afford users options are better, such as equipping all roll-in showers with folding seats. In facilities with multiple bathrooms or bathing facilities, it is generally advisable to provide different types of bathing fixtures to allow more options.
Elevator operation shall be automatic. Some amusement rides and attractions that have unique designs and features are not addressed by these requirements. In those situations, these requirements are to be applied to the extent possible. An example of an amusement ride not specifically addressed by these requirements includes “virtual reality” rides where the device does not move through a fixed course within a defined area. An accessible route must be provided to these rides. Where an attraction or ride has unique features for which there are no applicable scoping provisions, then a reasonable number, but at least one, of the features must be located on an accessible route.
CHAPTER 10: RECREATION FACILITIES
A parallel approach complying with 305 shall be permitted to lavatories and sinks used primarily by children 5 years and younger. Flush controls shall be hand operated or automatic. Hand operated flush controls shall comply with 309. Handrails shall be continuous within the full length of each stair flight or ramp run. Inside handrails on switchback or dogleg stairs and ramps shall be continuous between flights or runs.
806.3 Guest Rooms with Communication Features. Guest rooms required to provide communication features shall comply with 806.3. Bottom-hinged appliance doors, when in the open position, shall not be required to comply with 309.3.
Doors, Doorways, and Gates
The angle of the water stream shall be measured horizontally relative to the front face of the unit. Where spouts are located less than 3 inches of the front of the unit, the angle of the water stream shall be 30 degrees maximum. Where spouts are located between 3 inches and 5 inches maximum from the front of the unit, the angle of the water stream shall be 15 degrees maximum. The spout shall be located 15 inches minimum from the vertical support and 5 inches maximum from the front edge of the unit, including bumpers. Passenger loading zones shall provide access aisles complying with 503 adjacent to the vehicle pull-up space.
Seats shall comply with 610. 606.5 Exposed Pipes and Surfaces. Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact. There shall be no sharp or abrasive surfaces under lavatories and sinks.
ADA bathroom Door Requirements
The required clearance must be located so that it aligns with the control wall and extends 12″ minimum from the seat wall. This allows proper alignment with the seat for transfer from wheelchairs. No elements, including lavatories, can overlap this clearance as they would impede transfer. The seat wall or the flange around the face of prefabricated showers may slightly offset the clearance from the shower. It is important that this offset be minimized and to limit the gap between the clearance and the edge of the seat (which must extend to a point within 3″ of the compartment entry). When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs.
Mezzanines have sufficient elevation that space for human occupancy can be provided on the floor below. A short ramp cutting through a curb or built up to it. A standardized surface feature built in or applied to walking surfaces or other elements to warn of hazards on a circulation path. Interior or exterior circulation paths, rooms, spaces, or elements that are not for public use and are made available for the shared use of two or more people. Describes spaces and elements specifically designed for use primarily by people 12 years old and younger.
What's on ADA.gov
Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone, and from the passenger loading zone to a vehicular exit shall provide a vertical clearance of 114 inches minimum. In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches maximum above the finish floor where a parallel approach is provided. Diagonal or Corner Type Curb Ramps406.7 Islands.
602.7 Drinking Fountains for Standing Persons. Spout outlets of drinking fountains for standing persons shall be 38 inches minimum and 43 inches maximum above the finish floor or ground. Drinking Fountain Spout Location602.6 Water Flow. The spout shall provide a flow of water 4 inches high minimum and shall be located 5 inches maximum from the front of the unit.
The Standards provide specifications for a standard type and an alternate type of roll-in compartment. When existing bathing rooms are altered, the Standards apply according to the planned scope of work. If one bathing room on a floor is altered, the Standards apply to that room only; if all bathing rooms on a floor are altered, the Standards apply to each bathing room that would be required to comply in new construction. The scope of work also determines which technical requirements apply. If some, but not all, elements in a bathing room are altered, only those elements altered must comply.
Floor electrical receptacles shall not be required to comply with 309. Operable parts that are intended for use only by service or maintenance personnel shall not be required to comply with 309. Within areas of sport activity, protruding objects on circulation paths shall not be required to comply with 307. 202.5 Alterations to Qualified Historic Buildings and Facilities. Alterations to a qualified historic building or facility shall comply with 202.3 and 202.4.
For example, a play area is built in two phases. In the first phase, there are 10 elevated play components and 10 elevated play components are added in the second phase for a total of 20 elevated play components in the play area. When the first phase was completed, at least 5 elevated play components, including at least 3 different types, were to be provided on an accessible route. When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types, must be provided on an accessible route. 233.2 Residential Dwelling Units Provided by Entities Subject to HUD Section 504 Regulations.
No comments:
Post a Comment